Click thumbnail image for details
|
|
|
|
|
|
|
|
Cherf Cast Stand
|
Fromm Knee & Tibial Triangles
|
Sanders Extremity Positioning Tubes
|
Shereff Ankle Distractor
|
|
|
|
Cherf Cast Stand
Designed to assist in applying short leg casts
|
|
|
|
Designed by J. Cherf, MD
|
|
|
 |
The adjustable height permits optimal leg position for the seated patient and helps insure the application of a cast with the foot/ankle at 90 degrees to the leg. The foot is placed on the tongue of the stand. Stockinette is pulled over the foot and tongue. Cast padding and plaster/fiberglass is used in a routine direction. The cast stand is slipped forward disengaging the foot after the cast has hardened.
Product No: 2040
Base: 18.5" x 14.5"
Height: Adjusts from 14" to 23.75"
Foot Rest: 11" x 1.75"
|
|
|
Fromm Knee & Tibial Triangles
Used for femur and tibia positioning during nailing, repairs and fractures
|
|
|
|
Designed by Stuart E. Fromm, MD
|
|
|
|
Designed to position and hold the femur and tibia during intramedullary nailing of the tibia, ligament repairs and extremity fractures. Allows knee to be flexed greater than 90° to allow reaming and nail insertion without displacing fracture. The triangles are available in three heights, 11", 14", and 16". The two smaller triangles are designed to fit inside the larger triangle for storage. They are supplied with an autoclavable silicone cushioning pad and velcro* straps. The triangles are also radiolucent and gas or steam sterilizable.
*Velcro® is a registered trademark of the Velcro Companies.
Product No's:
Angles: Top 30°, Two Bottom 75°
2760-00 [Set of Three]
2760-01 [11"] • Base: 6", Height: 11"
2760-02 [14"] • Base: 7", Height: 14"
2760-03 [16"] • Base: 9", Height: 16"
2760-S [Straps–Pkg of 18]
2760-P [Pad]
|
|
|
Sanders Extremity Positioning Tubes
Designed to support the knee and ankle during lower extremity surgery
|
|
|
|
Designed by Richard A. Sanders, MD
|
|
|
|
|
The 6" tube lifts the knee off the operating table and allows for approximately 30° of knee flexion. Very useful for closure of total knee incisions, supporting fractures of the distal femur, and tibia plateau fractures.
The 4" tube elevates the foot and ankle for ankle fracture surgery.
The tubes are made of aluminum, allowing them to be autoclaved. They help eliminate the need for rolled sheet bolsters.
Product No’s:
Overall Width: 8"
2740-01 • 4" diameter
2740-02 • 6" diameter
|
|
|
© 2010 Innomed, Inc., All rights reserved.
|
